General Safety Instructions; Safe Operation - Parkside PSBS 240 B2 Originalbetriebsanleitung

GB MT
Never use faulty grinding disks.
Do not dispose of electrical equip-
ment in household waste.
Dimensions grinding disk
Dimensions grinding belt
Symbols in the manual:
Warning symbols with in-
formation on damage and
injury prevention.
Instruction symbols (the instruction
is explained at the place of the
exclamation mark) with information
on preventing damage.
Help symbols with information on
improving tool handling.

General safety instructions

Safe operation:

Keep work area clear. Cluttered
•
areas and benches invite injuries.
Consider work area environ-
•
ment.
- Do not expose tools to rain. Do not
use tools in damp or wet locations.
Water entering a power tool will in-
crease the risk of electric shock.
- Keep work area well lit.
- Do not use tools in the presence of
fl ammable liquids or gases.
Power tools create sparks which may
ignite the dust or fumes.
Guard against electric shock.
•
Avoid body contact with earthed or
grounded surfaces (e.g. pipes, radia-
tors, ranges, refrigerators).
54
Keep other persons away.
•
Do not let persons, especially children,
not involved in the work touch the tool
or the extension cord and keep them
away from the work area.
Store idle tools. When not in use,
•
tools should be stored in a dry locked-
up place, out of reach of children.
Do not force the tool. It will do
•
the job better and safer at the rate for
which it was intended.
Use the right tool.
•
- Do not force small tools to do the job
of a heavy duty tool.
- Do not use tools for purposes not
intended; for example do not use cir-
cular saws to cut tree limbs or logs.
Use of the power tool for operations
different from those intended could
result in a hazardous situation.
Dress properly.
•
- Do not wear loose clothing or jewellery,
they can be caught in moving parts.
- Anti-slip footwear is recommended
when working outdoors.
- Wear protective hair covering to con-
tain long hair.
Use protective equipment.
•
- Use safety glasses.
- Use face or dust mask if working op-
erations create dust.
Connect dust extraction equip-
•
ment. If the tool is provided for the
connection of dust extraction and col-
lecting equipment, ensure these are
connected and properly used.
Do not abuse the cord. Never
•
yank the cord do disconnect it from the
socket. Keep the cord away from heat,
oil and sham edges.
Secure work. Where possible use
•
clamps or a vice to hold the work. It is
safer than using your hand.