Possible Cause; Troubleshooting - Parkside PKS 1500 A2 Bedienungs- Und Sicherheitshinweise

Fault

Possible cause

Motor does not work. Motor, cable or plug defective, fuses burnt.
The motor starts up slowly Voltage too low, coils damaged, capacitor burnt.
and does not reach
operating speed.
Motor makes excessive Coils damaged, motor defective.
noise.
The motor does not reach Circuits in the network are overloaded (lamps,
its full power. other motors, etc.).
Motor overheats easily. Overloading of the motor, insufficient cooling of
the motor.
Reduced cutting power Saw blade too small (ground too much).
when sawing.
Saw cut is rough or wavy. Saw blade dull, tooth shape not appropriate for
the material thickness.
Workpiece pulls away Excessive cutting pressure and/or saw blade not
and/or splinters. suitable for use.

Troubleshooting

Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger! Check fuses
and replace as necessary.
Contact the utility provider to check the voltage. Arrange
for inspection of the motor by a specialist. Arrange for
replacement of the capacitor by a specialist.
Arrange for inspection of the motor by a specialist.
Do not use any other equipment or motors on the same
circuit.
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor.
Readjust end stop of the saw unit.
Resharpen saw blade and/or use suitable saw blade.
Insert suitable saw blade.
GB/MT 45