Operation; Changing The Battery; Inserting Or Replacing A Tool / Collet - Parkside PMGS 12 C3 Bedienungs- Und Sicherheitshinweise

Wear a dust mask!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
D o not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.
A void abrading paints containing lead
or other substances hazardous to health.
D o not machine materials containing
asbestos. Asbestos is a known carcinogen.
D o not machine moist materials or
damp surfaces.
NOTE! Do not allow the tool to come to a
standstill by overloading it!
and allow it to come to a standstill be-
fore you put it down.
clean, dry and free of oil or grease.
This device is not intended to be used by per-
sons (including children) with impaired physi-
cal, sensory or mental capacity or lacking the
experience and / or knowledge. Always super-
vise children to ensure they do not play with
the tool.
If the external connection wire / cable(s)
for this transformer is / are damaged, it / they
must be replaced by the manufacturer or its cus-
tomer service, or a similarly qualified person to
avoid hazards.
Safety isolating transformer
fail-safe
Fusible cut-out

Operation

Q
N ever use the device for a purpose
for which it was not intended or with
non-original parts / accessories. The use
of tools or accessories other than those recom-
mended in the operating instructions could lead
to you suffering an injury.
General safety advice for electrical power tools / operation
NOXIOUS FUMES!
Switch the device off
Always keep the device

Changing the battery

ATTENTION!
Do not leave drained battery in the device, as
even leak-proof batteries can corrode, releasing
chemicals which could be harmful to your health
or ruin the device.
Do not leave batteries lying about carelessly.
Children or pets could swallow them. If acciden-
tally swallowed seek immediate medical attention.
Remove the batteries from the device when it
will not be used for extended periods to prevent
leaks.
Touching leaked or damaged batteries may
cause chemical burns. Therefore wear suitable
protective gloves in this event.
Ensure batteries are not short-circuited. Never
throw batteries into fire.
Do not recharge batteries. Explosion hazard!
Ensure the LED light is switched off. Remove the
three battery cover screws at the back of the
grip collar with LED
Remove the drained battery and replace with a
new battery (button cell LR41). Please note the
correct polarity when inserting the batteries.
Close the battery compartment by fastening the
three screws.
Inserting or replacing
Q
a tool / collet
P ress the spindle lock
R otate the clamping nut
engages.
L oosen the clamping nut
tion key .
23
I f a tool is already inserted, remove it.
F irst insert the tool you wish to use through the
clamping nut before you insert it into the
5
collet suitable for the tool shaft.
18
P ress the spindle lock
I nsert the collet
18
tighten the clamping nut
the combination key
.
6
and keep it pressed.
7
until the lock
5
with the combina-
5
and keep it pressed.
7
into the threaded insert and
on the thread using
5
.
23
GB/MT 55