Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Instructions For Fine Spray Systems; Initial Use; Hvlp Properties; Connecting The Device - Parkside PDFP 500 A1 Bedienungs- Und Sicherheitshinweise

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Safety advice / Initial use
Safety instructions for
fine spray systems
K eep your work area clean, well lit
and free of paint or solvent containers,
rags and other combustible materials.
Potential danger of spontaneous combustion.
Keep fully functioning fire extinguishers / extin-
guishing equipment available at all times.
E nsure good ventilation in the spray-
ing area and sufficient quantities of
fresh air through-out the room. Evapo-
rating flammable solvents create an explosive
environment.
D o not spray or clean with materials
with a flashpoint below 21°C. Use
materials on the basis of water, low-
volatile hydrocarbons or similar ma-
terials. Highly volatile evaporating solvents
create an explosive environment.
D o not spray in the area of ignition
sources such as static electricity sparks,
open flames, pilot lights, hot objects,
motors, cigarettes and sparks from in-
serting and disconnecting power cords
or the operation of switches. Such sources
of sparks can lead to ignition of the surround-
ing area.
D o not spray any materials for which
it is not known whether they pose a
danger. Unknown materials can create dan-
gerous conditions.
W ear additional personal protective equipment
such as appropriate protective gloves and pro-
tective masks or respirators when spraying or
handling chemicals. The wearing of protective
equipment in such conditions reduces exposure
to harmful substances.
D o not spray on yourself, other people
or animals. Keep hands and other body
parts away from the spray jet. If the
spray penetrates the skin, seek medi-
cal help immediately. The material being
sprayed can even penetrate the skin through a
glove and be injected into your body.
D o not treat an injection as a simple cut.
A high pressure jet may inject toxins
into the body and cause serious injuries.
24 GB
If the spray is injected into the skin, seek medical
help immediately.
P ay attention to any possible dangers
of the material being sprayed. Note
the markings on the container or the
manufacturer's information relating
to the material being sprayed, includ-
ing the instruction to use personal
protective equipment. The manufacturer's
in-structions must be followed to reduce the risk
of fire, as well as injuries caused by toxins, car-
cinogens, etc.
N ever spray without the nozzle head
in place. The use of a special nozzle insert
with the appropriate nozzle head reduces the
probability of a high-pressure jet penetrating
the skin and injecting toxins into the body.

Initial use

Q

HVLP properties

Q
This device uses an HVLP system (High Volume Low
Pressure). It ensures the increased application of
(paint) materials with lower consumption.
Important: Do not exceed the maximum working
pressure of 3 bar.

Connecting the device

Q
O perate the product only with cleaned, con-
densate- and oil-free compressed air and never
exceed the maximum working air pressure at
the device of 3 bar.
T he compressed air source must be fitted with a
(filter) / pressure reducer so that the air pressure
can be regulated.
In order to operate this device you require a flexible
compressed air hose with quick-release coupling
and an appropriate source of compressed air.
Observe the operating and safety instructions of the
compressed air source and any special instructions
concerning paint preparation.
Note: Ensure the correct working pressure. An
excessive working pressure leads to increased fine

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis