Troubleshooting - Pioneer SGY-PM930H Bedienungsanleitung

Troubleshooting

EN
Refer to the following suggestions if you have any problems installing or using
the product.
If you cannot find what you want to know here, ask the shop where you
bought the product.
■ I cannot pair with the Cyclocomputer.
Cause
The battery is almost empty.
(Battery voltage target is 2.5V or
less)
( + ) or (–) side of the battery is
installed in the opposite side.
There are other 2.4 GHz wireless
equipment or microwave ovens
near by.
Another sensor is paired with the
Cyclocomputer.
Transmitter is not starting.
28
Solution
If the LEDs do not light for more than 5 seconds after
installing the batteries, remove the batteries once,
and after more than 1 minute, install them again. If the
LEDs still do not light, the battery may be almost empty.
Replace the battery with a new one.
Install the battery in the proper side (Page 12).
Move away from other wireless equipment or microwave
ovens. Move the sensor closer to the Cyclocomputer and
pair them.
Move away from other sensors by more than 10 m or
specify the device number to pair the Cyclocomputer.
Refer to the Installation Manual (For Web) for details.
http://pioneer-cyclesports.com/us-en/support/products/
Reinstall the battery of the transmitter or rotate the
bicycle's crank set more than three rotations to start the
transmitter. The transmitter will start in 5 minutes, so you
must pair in that time.
If the problem is not resolved by the above, confirm
the magnet installation status from the shop where you
bought the product.