Fly The Quadcopter - Blade INDUCTRIX BL FPV Bedienungsanleitung

Fly the Quadcopter

The LEDs indicate the front and back of the quadcopter. The white LEDs
indicate the front. The red LEDs and tail light indicate the back.
Takeoff
Arm the motors by pressing the arming switch. Increase the throttle
until the model is approximately 2 ft. (600mm) off the ground in a low-
level hover and concentrate on balancing the throttle stick's position so
that the quadcopter holds a steady hover altitude. In some cases, you
may need to make a few short "hops" to an altitude of just a few inches
until you become familiar with the control inputs and trim settings
required to maintain a steady hover and altitude.
Hovering
The Inductrix quadcopter requires minor throttle adjustments to
®
maintain its altitude in hover. Remember to keep these throttle
adjustments as minimal as possible. Large adjustments could result in
a loss of control or a possible crash.
While attempting to establish a low-level hover, check to see if any
trim adjustments are required to keep the quadcopter from drifting
in various directions. If you find that it constantly drifts without any
directional control input, land the model before making any adjustments
to the trim settings.
• If the nose of the quadcopter rotates to the left or right, adjust the
rudder trim in the opposite direction.
15
EN