Herunterladen Inhalt Inhalt Diese Seite drucken

Preparing The Tool For Use; Switching On /Off; Adjusting The Speed; Switching Direction Of Rotation - Parkside PABS 18 A1 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PABS 18 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Before first use / Preparing the tool for use
In the first gear (Gear selector switch
in Position: 1)
A speed of up to approx. 400 rpm can be achieved
and a high torque. This setting is intended for use
with all screwing tasks and for accessories.
In the second gear (Gear selector switch
in Position: 2)
It achieves a speed of up to approx. 1300 rpm, for
the carrying out of drilling tasks.

Preparing the tool for use

Q

Switching ON /OFF

Q
Switching on:
j
To start the appliance squeeze on the On /
Off switch
and then keep it pressed down.
4
Switching off:
j
To stop the appliance, release the On / Off
switch
.
4

Adjusting the speed

Q
The On / Off switch
control device. Slight pressure on the On / Off
switch
will cause the rotation speed to slow down.
4
With increased pressure, the rotational speed will
increase.
Note: The integrated engine brake means that the
device will come to a fast standstill.

Switching direction of rotation

Q
j
To switch the direction of rotation, push the
direction of rotation switch
right or to the left.
12 GB/IE
has a variable speed
4
to either the
3

Tips and Tricks

Q
1
j
Before you use the appliance, check to see
that the screw or drill bit is properly fitted, i.e.
located centrally in the chuck.
j
Screw bits are designated with their dimensions
and their shape. If you are unsure, always try
1
the particular screw bit out to see whether it sits
in the screw head without any free play.
Torque:
j
Smaller screws and bits in particular can be
easily damaged if you adjust the appliance
with too high a torque and/or rotation speed.
Hard screwdriving conditions (into metal):
j
Particularly high torques can occur, for example
with metal screws tightened by socket tool bits.
Select a lower rotation speed.
Soft screwdriving conditions (e.g. into
soft wood):
j
You should also select a low speed in order not
to damage the wood workpiece surface through
contact with the metal screw head. Use a coun-
tersinker.
When drilling into wood, metal and other
materials, take note of the following advice:
j
With small diameter drill bits use a high drill
speed. for large diameter drill bits, use a low
drill speed.
j
for hard materials, select a low drill speed.
for soft materials, select a high drill speed.
j
Secure or fix down the workpiece (if possible)
in a clamp or vice.
j
Mark the intended position of the hole with a
centre punch or a nail and select a low drill speed
for drilling.
j
Take the rotating drill bit out of the hole frequently
so that swarf or drill dust can be re-moved and
the hole and tool is ventilated.
Drilling in metal:
j
Use a metal drill bit (HSS). for the best results,
you should cool the bit with oil. Metal drill bits
can also be used to drill into plastic.

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis