Aluprof DM R series Anleitung Seite 8

1. Programming the first transmitter
I
x2 BIP
Press the SET button (on
tubular motor's head) one
time, 2 short beep will be
heard immediately (2xBIP).
II
x2 BIP
Turn on the power, 2 short
beep will be heard immediately
(2xBIP).
2. Programming the direction of movement
I
x2 BIP
Press the SET button
(which is on the head of the
motor) for 6 seconds.
II
x2 BIP
Turn on the power, 2 short
beep will be heard immediately
(2xBIP).
x2 BIP
In an interval of about two
seconds, press the "P2" button
twice and you will hear an
acoustic signal (x2 BIP)
x2 BIP
In an interval of about two
seconds, press the "P2" button
twice and you will hear an
acoustic signal (x2 BIP)
OK
Hold the button till the tubular motor will
make three short beep (3x BIP). This means
that the directions of the movement have
been changed
x2 BIP
In an interval of about two
seconds, press the "P2" button
twice and you will hear an
acoustic signal (x2 BIP)
x1 BIP
Press the "UP" button and you
will hear an acoustic signal
(x1 BIP)
x1 BIP
Press the "UP" button and you
will hear an acoustic signal
(x1 BIP)
x1 BIP
Press the "DOWN" button
and you will hear an acoustic
signal (x1 BIP)
- 8 -
OK
After correct programming
the tubular motor will make 6 short
beeps (6xBIP) and it is ready
to regular using.
OK
After correct programming
the tubular motor will make 6 short
beeps (6xBIP) and it is ready
to regular using.
OK
After correct programming
the tubular motor will make 6 short
beeps (6xBIP) and it is ready
to regular using.