Yamaha WaveRunner Gp1200R Wartungshandbuch Seite 328

– +
ELEC
IGNITION SYSTEM
2. Measure:
Pickup coil output peak voltage
Below specification → Replace the
pickup coil.
Pickup coil output peak voltage:
White/red (W/R) –
Black/orange (B/O)
Unloaded
r/min
Cranking
V 5
NOTE:
The starter motor will not operate when the
test harness on the output side coupler is
disconnected to measure the unloaded
peak voltage for the pickup coil(s). There-
fore, connect the black lead of the test har-
ness to the ground with a lead.
3. Measure:
Lighting coil output peak voltage
Below specification → Replace the
lighting coil.
Lighting coil output peak voltage:
Green (G) – Green (G)
Unloaded
r/min
Cranking
V 9
NOTE:
Make sure the output lead (red lead) of the
rectifier/regulator is disconnected when
measuring the output peak voltage.
The starter motor will not operate when
the test harness on the output side cou-
pler is disconnected to measure the
unloaded peak voltage for the lighting
coil. Therefore, connect the black lead of
the test harness to the ground with a lead.
7-13
Loaded
2,000 3,500
2.8 7.9 11
Loaded
2,000 3,500
9 14 14
E