Herunterladen Inhalt Inhalt Diese Seite drucken

Checking The Charge Status Of The Battery; Working Instructions; Planing; Chamfering Edges - Parkside PHA 12 A1 Originalbetriebsanleitung

Akku-hobel
Vorschau ausblenden Andere Handbücher für PHA 12 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 58
GB MT
Checking the charge status
of the battery
The battery charge indicator (
lises the state of charge of the battery (
6) while the device is operating. Press and
hold the power button to view.
3 LEDs are on (red, yellow, green):
Battery charged
2 LEDs are on (red, yellow):
Battery partially charged
1 LED is on (red):
Battery needs to be charged
Charge the battery (
only the red LED on the level indica-
tor is illuminated.

Working instructions

Work safely, giving due con-
sideration to the next steps!

Planing

Attention! Risk of kickback!
Make sure the planer is swit-
ched on before guiding it over
the workpiece to be machined.
·
Secure the workpiece to be machined.
·
Set the desired cutting depth.
·
Place the device's planer sole and
V-groove onto the workpiece.
·
Switch on the device and guide it with
a uniform forward motion over the
workpiece to be machined.

Chamfering edges

The V-groove at the front of the planer sole
is for chamfering edges.
54
·
2) signa-

Maintenance and Care

6) when
Two blades are installed in the planer
shaft. The blades have two cutting edges,
which can be turned around. Always use
and replace the blades in pairs. Do not
attempt to sharpen the blades!
1. Unscrew the two nuts (15) with the
2. Using the Allen key (9), turn the screws
3. Clean the blade holder (14) if necessary.
4. Insert the turned-over blade or new bla-
Place the planer's V-groove (
the edge of the workpiece and guide it
along the edge.

Replacing planer blades

Always remove the recharge-
able battery before carrying
out work on the device.
Risk of injury!
Cutting hazard! Do not hold
the planer blade by its cutting
edges.
Always change the blades one after
the other. In this way, you can use
the one that is still installed to guide
you during fitting.
Replacement blades can be purcha-
sed from customer service (see 'Spa-
re parts/accessories').
spanner (10).
(16) in a clockwise direction as far as
you need to in order to push the blade
(17) out of the blade holder (14).
Use a small piece of wood to push it out.
de into the blade holder (14).
The groove in the blade must point in
the direction of the part of the planer
13) on

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis