•
The device may only be powered
with SELV (Safety Extra Low Volt-
age) as marked on the device.
•
Charge the battery before the first
time of use.
•
Always take heed of the applicable
safety instructions as well as the en-
vironmental protection regulations
and information.
•
The warranty excludes all defects
caused by improper handling.
Recharging the battery
1. Connect the charger plug to the
charging socket (
vice.
2. Plug the battery charger (
into a mains outlet.
3. When the battery is fully re-
charged unplug the battery
charger (
The charge state indicator (
Red LED lights up
Green LEDs light up
Checking the battery charge
level
The battery's charge level is indicated by
the charge state indicator (
The state of charge of the battery is dis-
played by illuminating the appropriate LED
lights. In order to activate the display, the
on/off switch (
9) must be pressed.
Green LED lights up
Battery fully charged
Red LED lights up
Battery needs to be charged
6) of the de-
11)
11) from the mains.
5) lights up.
Battery charging
Battery fully
charged
5).
Starting up
Before the starting up must
the transport safety (
removed.
Open the transport safety (
move the transport safety of the bit holder
(
3).
Operation
Switching on/off
Press the on/off switch (
vice. To turn it off, release the on-off button.
If you move the direction switch (
the middle position, the device is secured
against being switched on.
The LED lamp (
to be used by activating the switch
block. To do so, press the on/off
switch.
Direction switch
You can toggle between right (
(
) rotation by pushing the direction of ro-
tation switch (
8).
If you move the direction switch (
the middle position, the device is secured
against being switched on.
The direction changed may
only be performed in stand-
still mode!
GB
MT
1)
1) and re-
9) to start the de-
8) to
7) can continue
) and left
8) to
51