Cleaning And Maintenance - Parkside PLS 48 D2 Gebrauchanleitung

soldering work.
Clean the soldering tip
„
After cleaning, the soldering tip must be tinned. Tin the hot soldering tip
„
by melting the solder
Bring the soldering tip to the soldering point and heat it.
„
Bring the solder (with flux) between the soldering point and the soldering
„
tip.
Apply additional solder until the entire solder joint is covered.
„
Immediately remove the soldering tip to avoid overheating the molten
„
solder.
Let the solder solidify and avoid vibrations.
„
NOTE
The flux is either contained in the solder or it is applied separately.
f
When purchasing, please find out about the type of application
and the appropriate solder

Cleaning and maintenance

Clean the device after completing the work.
„
Use a cloth and a mild detergent if required to clean the housing.
„
Never use sharp objects, petrol, solvents or cleaners that can damage
„
plastic.
28
| GB | CY | IE | NI

on a moist solder sponge

.
WARNING! RISK OF INJURY! Always
unplug the
socket and allow it to cool down before
performing any work on the device .
device from
.

the mains
PLS 48 D2