Parkside PLS 48 D2 Gebrauchanleitung Seite 23

RISK OF BURNS! Before using, check that the tool tip is properly
„
attached to the device. Never touch the heated soldering tip or
the molten solder. There is a risk of burns. The device must be
allowed to cool down before changing, cleaning or checking any
components. The hot tool tip and its mounting must not come into
contact with skin, hair, etc. Risk of burns.
After working, allow the soldering iron to cool down only in the
„
air. Under no circumstances quench with water!
CAUTION! DANGER OF FIRE! Only use the multifunctional
„
holder to put down the hot soldering iron.
During work breaks, the soldering iron must be placed in the
„
multifunctional holder and the device must be disconnected from
the power source.
Keep the device away from inflammable material.
„
Do not apply excessive pressure to the tips during use. When
„
pressure is applied, the thin tips may bend.
A fire can be started if the device is not carefully handled.
„
Never leave the device unattended when switched on.
„
CAUTION! RISK OF INJURY! Keep your hands away from the
„
heated workpiece. Heat can be released through the workpiece.
Avoid contact of the hot soldering tip with the plastic parts of
„
PLS 48 D2
CAUTION DANGER OF ELECTRIC SHOCK!
Do not use the soldering station if
the handle, power cable or plug are
damaged . Never open
GB | CY | IE | NI
the device!
23
|