Set The Direction Of Rotation; Inserting/Replacing Bits; Torque Setting; Handle Setting - Parkside PSSA 4 A1 Originalbetriebsanleitung

GB IE NI
• Press the On/Off switch, the state of
charge of the battery is displayed by
turning on the 3 coloured LED lights:
red-yellow-green => Battery fully
charged
red and yellow =>
Battery appr. half charged
red => Battery is empty, please charge.

Set the direction of rotation

You can select the direction of rotation with
the direction switch (clockwise and anti-
clockwise direction) and secure the device
against accidental start up.
1. Wait for the device to shut-
down.
2. Clockwise direction:
Press direction switch (9)
to the right.
3. Anticlockwise direction:
Press direction switch (9)
to the left.
Switch lock: Bring direction
4.
switch to neutral position.
Direction switch may only be acti-
vated at a standstill to prevent dam-
age to the transmission.

Inserting/replacing bits

Prior to commencing any work
on the device, bring the direction
switch (
in order to prevent an accidental
start up.
1. Insert the desired bit (14) or bit
holder (15) into the bit adapter
(11). It locks into place audibly.
2. To remove the bit or bit holder
pull the spring sleeve (1) back.
12
CY
9) to the neutral position
3. With the spring sleeve (1) pulled
back remove the bit or bit holder
from the bit adapter (11). Release
the spring sleeve.

Torque setting

Always turn off the device, before
setting the torque.
1. Turn the adjusting ring (2) to select
the desired torque:
Step 1 -->
Step MAX --> highest torque
Screws:
Drilling:
2. Start with a lower torque step
and increase according to
requirement.
The necessary torque is dependent
on:
- the type and hardness of the
material to be treated;
- the type and length of the screws
used.

Handle setting

Prior to commencing any work on the
device, bring the direction
switch ( 9) to the neutral position in
order to prevent an accidental start up.
The device can be locked in two hand settings:
- Pistol grip position
- Rod position
Press the release key PRESS (4) and
turn the handle (6) of the device by
180°. It locks into place audibly.
lowest torque,
(5 Nm).
Steps 1 - 6
Step MAX.