Practical Tips; Assembly; Mount Additional Handgrip; Assemble/Set Protective Hood - Parkside PWSA 18 A1 Originalbetriebsanleitung

GB IE

Practical tips

Scrubbing wheels:
Never use a cutting wheel for
scrubbing !
Exert only moderate pressure on the work-
piece. Move the device evenly back and
forth.
A working angle of 30° to 40° achieves
the best results for scrub grinding.
Cutting disc:
Never use a scrubbing wheel
for cutting !
Only certiied, ibre-reinforced cutting or
grinding discs may be used.
In general, work with small scrubs. Exert
only moderate pressure on the workpiece.
Always work in the counter-direction. This
ensures that the device is not pushed out of
the cut through lack of control.
Cutting of stone materials:
• It is best to use a diamond cutting disc
to cut stone materials. Make sure in any
case that the cutting disc is suitable and
labelled for your application.
• When cutting stone materials, ensure
that the dust extraction is suficient.
• Wear a dust protection mask.
• The device may only be used for dry
cutting/dry grinding.
18
Information on building statics:
Slits in structural walls are subject to the
standard DIN 1053 Part 1 or country-
speciic regulations. These regulations must
be observed without fail. Before begin-
ning work you should ask the structural
engineer, architect or relevant construction
supervisor for advice.

Assembly

Caution! Risk of injury!
- Ensure that you have suficient
space in which to work, and
that you do not endanger other
people.
- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug be-
fore changing the setting on the
device

Mount additional handgrip

The device must only be op-
erated with the handgrip
mounted.
Screw the additional handgrip (2), de-
pending on the type of work, to the left,
right or above the device using the thread-
ing for the handgrip (4).
Assemble/set protective
hood
Adjust the protective cover such that any
sparks or detached parts cannot hit either
the user or any bystanders.
The protective cover must also be posi-
tioned such that the sparks cannot ignite