Removing / Inserting The Battery; Recharging The Battery; Used Batteries; Checking The Battery Charge Level - Parkside PWSA 18 A1 Originalbetriebsanleitung

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
• Charge the battery before the irst time
of use. Do not briely charge the battery
several time in a row.
• Recharge the battery when you notice
that the appliance is becoming slower.
• If a fully recharged battery lasts for con-
siderably shorter operating times, the bat-
tery is used up and needs to be replaced.
Only use an OEM spare battery available
from our Customer Service.
• Always take heed of the applicable safety
instructions as well as the environmental
protection regulations and information.
• The warranty excludes all defects
caused by improper handling.
Removing / inserting the
battery
1. To remove the battery (9) from
the appliance, press the release
button 10) on the battery and
pull out the battery.
2. To insert the battery (9), place it
on the guide track and push it
back into the appliance. It will
audibly snap in.

Recharging the battery

1. Remove the battery (9) from the
appliance.
2. Insert the battery (9) in the charg-
ing compartment of the battery
charger.
3. Plug the battery charger into a
mains outlet.
4. When the battery (9) is fully
recharged unplug the battery
charger from the mains.
5. Pull the battery (9) out of the bat-
tery charger.
Green LED lashes up without battery
Charger ready
Green LED lights up
Battery such alleged charged
Red LED lights up
Green LED lashes with battery:
Battery has to be charged in advance for
30 minutes before charging starts
Red and green LED lashes
Red and green LED lights up
Battery too cold or too warm. Battery can-
not be charged

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable safety
instructions as well as the environmental
protection regulations and information
(see "Cleaning and Maintenance").
Checking the battery charge
level
The battery's (9) charge level is indicated
by the charge state indicator (8).
Press the activation button battery indicator
on the battery.
The LEDs indicate the battery's charge
level.
red-yellow-green = Battery fully charged
red and yellow
red = Battery needs to be charged
GB
Battery charging
Battery defect
= Battery half charged
IE
17