To charge the battery, use
•
only the charger supplied.
Risk of ire and explosion. This en-
sures that the safety of the device
is maintained.
Before each use, check the
•
charger, cable and plug
and have them repaired by
qualiied professionals and
only with original parts. Do
not use a defective charger and
do not open it up yourself. This en-
sures that the safety of the device
is maintained.
Connect the charger only to
•
a socket with an earth. En-
sure that the mains voltage
matches the speciications
on the charger rating plate.
Risk of electric shock.
Disconnect the charger from
•
the mains before closing or
opening connection to the
battery / power tool / de-
vice.
Keep the charger clean and
•
away from wet and rain.
Do not use the charger out-
doors. Dirt and the entry of water
increase the risk of electric shock.
Operate the charger only
•
with the appropriate origi-
nal batteries. Charging other
batteries may result in injuries and
risk of ire.
Avoid mechanical damage
•
to the charger. This can result in
internal short circuits.
Do not operate the charger
•
on a combustible surface
(e.g. paper, textiles). Risk of ire
due to heating during charging.
If the power cable for this equip-
•
ment is damaged, it must be re-
placed by the manufacturer, a cus-
tomer service agent of the same
or a similarly qualiied person in
order to prevent hazards.
The battery of the appliance is not
•
fully charged at the time of deliv-
ery. It therefore needs to be fully
recharged before you use it for
the irst time. For the irst recharge
cycle we recommend that you
charge the battery for about 1
hour. Slot the battery into the base
and plug the battery charger into
a mains outlet.
When the battery is fully charged,
•
unplug the charger from the mains
and from the appliance. Charging
time is approx. 1 hour.
Do not charge the battery continu-
•
ously since this may damage the
battery cells. Note: Repeatedly
charging small capacities may
damage the battery cells. Re-
charge the battery only if the appli-
ance is becoming slow.
Do not use the charger to charge
•
non-rechargeable batteries.
Safety instructions for all
applications
Common safety instructions for
grinding, sanding, working with
wire brushes and cutting grinders:
• This electric tool is to be used as
a grinder, sander, wire brush
and cutting grinder. Follow all
safety instructions, directives, il-
lustrations and facts which you
receive with the device. If you do
not follow these instructions, an electri-
cal shock, ire and/or serious injury
may occur.
GB
IE
11