Blaupunkt HCS201 Bedienungsanleitung Seite 7

HCS201
1. Trimming head with steel blades
2. On/Off button
3. Charge indicator
4. 3mm/6mm limit comb
5. 9mm/12mm limit comb
HAIR CLIPPER OPERATION
Select the appropriate limit comb (cut hair length is indicated on the side of the limit comb). Place the
limit comb on the hair shaver.
Switch the shaver on with the On/Off button. Slowly move the appliance over the hair. It is
recommended to shave "against the grain", against the direction of the hair growth.
Note: Make sure you remove any excess cut hair from the limit comb.
Having finished clipping, remove all hair from the trimming head.
HAIR CLIPPER CLEANING
Prior to cleaning the appliance, ensure that it is switched off and not being charged.
Clean the limit combs under running water.
Sweep the blades with the brush. Remove the trimming head by pressing down gently on the blades,
as shown in figure 3. The trimming head may be cleaned under running water. Remove impurities with
a brush from the inside of the appliance.
It is recommended that a little machine oil is applied onto the cleaned blades.
6. Socket
7. Power cord
8. Cleaning brush
9. Oil
10. Comb
5