Technical Specification - Velleman SOL30UC12V Bedienungsanleitung

• Reverse polarity protection: in order to prevent possible damage the regulator
will not function when reversed connecting polarity is detected. Correct the
polarity to use the regulator.
7. Troubleshooting
Problem
Charging not 1. Reverse polarity
indicated on 2. Loose connection
display when 3. Not enough sunlight
solar panel is
connected
No output on 1. Load switch off
load 2. Battery not connected,
loose connection or wrong
connections
polarity.
3. Polarity load reversed
4. Over-discharge
protection enabled
5. Short circuit or overload
protection enabled
8.

Technical Specification

Solar input current (max.)
Load current (max.)
Solar input voltage (max.)
Over-charge protection
Over-discharge protection
Output voltage
No-load current
Voltage loss charging circuit
Voltage loss discharging circuit
Operating temperature
Dimensions regulator
weight
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulted from (incorrect) use
of this device.
For more info concerning this product, please visit our website
www.velleman.eu.
The information in this manual is subject to change without prior notice.
00 (15/09/2008)
SOL30UC12V & SOL30UC24V
Possible cause Possible solution
1. Correct polarity
2. Secure connection(s)
3. Reposition solar panel
1. Press switch [3]
2. Connect a battery to the regulator,
check correct polarity and secure
connection
3. Correct load polarity
4. Disconnect load and fully recharge
battery
5. Verify that load is not short circuited
and draws no more than 30A. Press
switch [3] when everything is OK.
SOL30UC12V
22V
14.5V±0.2V
10.7V±0.2V
12VDC
<18mA
-25°C ~ 60°C
160 x 95 x 40mm
6
SOL30UC24V
30A
30A
50V
29.0V±0.2V
21.4V±0.2V
24VDC
≤0.4V
≤0.2V
±350g