Setting Functions/Scsi Id; Bw-Rs101 Function Settings - Sony BW-RS101 Benutzerhandbücher

Setting Functions/SCSI ID

BW-RS101 Function Settings

Use the function switches A to P on the rear panel of the unit to set the unit's
functions and SCSI ID according to the host computer and software that you are
using. Make sure that the unit is off before setting the switches.
A B C D F F G H
I
O
Switch Function
A Terminator Power
B Force CAV
C Background format
control
D Reserved*
E Reserved*
F Inhibit Verify
G Write Cache control
H Device Type
I SCSI Parity Check
J Reserved*
K Reserved*
L Reserved*
M SCSI ID 3
N SCSI ID 2
O SCSI ID 1
P SCSI ID 0
BW-RS101 Function switch settings
Note
• Reserved*
Do not set any of the reserved switches to 1, changing the reserved switches
setting may cause the unit failure.
I J K L M N O P
1
Supply POWER to the Supply POWER to the
terminator enabled terminator disabled
All operations are Optimum mode
performed in CAV enabled. (Automatic
seek mode. CAV/CLV selection)
Background Format Background Format
mode enabled mode disabled
—
Do not verify writes Verify write operations
Write caching disabled Write caching enabled
Report 00H as device Report 07H as device
type (Direct Access type (Optical Memory
device) device)
SCSI parity check SCSI parity check
enabled disabled
—
To set the SCSI ID, see "BW-RS101 SCSI ID
Settings" on page 17.
Setting Functions/SCSI ID
0
:Factory Settings
15