Hardware Installation; Software Installation - Asus DVD-E616P1 Schnellinstallationsanleitung

Quick Installation Guide

Hardware Installation

1. Turn off your computer and any peripheral devices connected to it.
2. Use a grounded wrist strap or touch a safely grounded object or a metal object,
such as the power supply case, before handling the device to avoid damaging it
due to static electricity.
3. Remove the computer cover.
4. Configure the DVD-ROM drive jumpers to set the device to master or slave
mode before installing it into the chassis. Use jumper blocks to short the pins to
your desired setting. (See page 13 for details.)
5. Insert the DVD-ROM drive into an
available 5.25-inch bay.
6. Connect a 4-pin power supply cable to
the DC input connector of the
DVD-ROM drive.
7. Connect one end of the IDE ribbon
cable to the IDE connector at the back
of the DVD-ROM drive, matching the
colored stripe on the cable with Pin 1
on the IDE connector. Connect the
other end of the IDE cable to the IDE
connector on the motherboard.
8. Connect one end of the 4-pin audio cable to the audio output connector of the
DVD-ROM drive. Connect the other end to the audio connector of an installed
sound card, or to the audio connector on the motherboard, if available.
9. Slide the DVD-ROM drive into the bay and secure it with four screws.
10. Replace the computer cover.
11. Turn on your computer.

Software Installation

Windows ® 98SE/2000/ME/XP automatically detects the current settings for
your drive and installs the appropriate driver.
24