Network Parameters; Alarm Set - Monacor AHR-40 Bedienungsanleitung

Main Stream: detailed settings please refer to DVR local
setting (chapter 6.2.2.3 on page 38). Herein allow user
modifies the resolution, frame rate, Bit rate and audio of the
record channel.

7.3.3.3 Network Parameters

Unfold <Network> option to enter into its sub-options: Net-
work, sub stream, Email, mobile and DDNS configuration.
1. Network
The model support three network type, including Static, DHCP
and PPPoE. System default <Static> as its network type. User
could allocate IP and perform Port forwarding for DVR accord-
ing to different router. When set <UPNP> to "Enable", user no
needs to perform port forwarding. Once you modify the net-
work parameters successfully, DVR will automatically restart.
For details parameters please refer to below fig. 7-21, fig.
7-22 and fig. 7-23:
50
2. Sub stream
shown as fig. 7-24: Relative parameters should be consistent
with DVR local setting (chapter 6.2.4.4 on page 42).
Fig. 7-20
3. Email setting
Click [Email setting] option to allow you set alarm email con-
figuration parameters shown as fig. 7-25. Detailed parameters
should be consistent with DVR local setting (chapter 6.2.4.5
on page 42).
4. DDNS Setting
After user applies for DDNS service shown as fig. 7-26, you
could enable <DDNS> function under any one network type
mode (Static, DHCP and PPPoE). Now you remotely visit the
DVR through domain name (http: //domain name: port No).
Details setting should be consistent with DVR local setting
(chapter 6.2.4.6 on page 42).
Fig. 7-21

7.3.3.4 Alarm Set

Click <Alarm> option to unfold its sub-options: Motion, I /O
Fig. 7-22
Alarm shown as fig. 7-27.
Fig. 7-23
Fig. 7-24
Fig. 7-25
Fig. 7-26
Fig. 7-27