Display; Live Mode; Output Mode - Monacor AHR-40 Bedienungsanleitung

Display

Record
Search
Main
Network
Menu
Alarm
Device
System
Advanced
Fig. 6-3 Menu structure
Live Set
Output Set
Privacy Zone
Record Parameters
Schedule
Main Stream
Record Search
Event Search
Log Search
Network Set
Sub Stream
Email Set
DDNS Seth
Motion Detection
Alarm Set
HDD
PTZ Set
Serial Set
General
Users
System Information
Maintain
Event
6.2.1 Display

6.2.1.1 Live mode

Go to [Main menu  Display  Live] option and enter into
the <Display> setting interface shown as fig. 6-4.
Channel:
Allow you setup the channel you desired.
Name:
Allow you setup the channel name, and sys-
tem support up to eight characters or four
Chinese characters.
Position: Allow you setup the display position of each
channel.
Color:
Click [Setup] option to enter into the [Color
setup] interface shown as fig. 6-5.
Covert: Allow you enable [Live] surveillance screen
Show time: Allow you enable system time appear in the
<Live> screen.
Record time: When set to "Enable", you are allowed to
record system time into the record history.
Copy: Allow you copy all data of one channel to any
other one
Above fig. 6-5 is the Color Menu where you can adjust image
brightness, saturation, contrast and hue parameters of each
channel.
1. The modifications will be available after clicking [APPLY]
button on the bottom of the sub-menu windows and
being prompted to save and then clicking [ok] button.
2. If you want to cancel the modification, click [Exit] button
to exit the menu.
3. When clicking [DEFAULT] button, all values will be reset to
the value pre-set at the factory.

6.2.1.2 Output mode

Go to [Main menu  Display  Output] and adjust the
parameters:
VGA / HDMI
Resolution: Allow you select VGA or HDMI output, in-
cluding 800 × 600, 1024 × 768, 1280 × 1024,
1440 × 900 and 1920 × 1080.
Transparency: Allow you adjust menu's transparency, and
its range is 1 – 128.
Fig. 6-4
Fig. 6-5
37