Herunterladen Inhalt Inhalt Diese Seite drucken

The Planing Process; Chamfering Edges (See Fig. H); Using The Guide Fence (See Fig. I); Using The Rebate Depth Stop (See Fig. J) - Parkside PEH 30 A1 Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 65

The planing process

Q
CAUTION! DANGER OF KICKBACK!
Always switch on the device before placing it
against the workpiece.
Set the required cutting depth.
Switch on the device.
Always place the front part of the sole
first on to the workpiece.
Guide the device with even forward movement
over the surface being planed.
Move the device forward at a slow rate and
ensure that the contact pressure acts evenly on
the sole
. Moving forward at too great a rate
9
results in a poorer surface quality and can lead
to blocking of the planing debris removal port.

Chamfering edges (see Fig. H)

Q
The V-grooves
in the front sole
10
to be used for simple chamfering of workpiece edges.
Use the V-groove most appropriate to your
desired chamfer width.
Place the planer with the V-groove
piece edge and guide the planer along the edge.

Using the guide fence (see Fig. I)

Q
Attach the guide fence
the fixing screw
7
Release the fixing nut
the desired distance.
Retighten the fixing nut
Exert some slight sideways pressure when guid-
ing the planer with the guide fence.
Using the rebate depth stop
Q
(see Fig. J)
Attach the rebate depth stop
with the fixing screw
Set the desired rebate depth with the rebate
depth stop
.
12
Make the required number of passes with the
planer until desired rebate depth is achieved.
down
9
allow the device
9
on the work-
10
to the device with
6
.
and set the guide at
8
.
8
to the device
12
.
11
Removing and installing a
Q
planer blade
DANGER OF INJURY!
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
CAUTION! The sharp cutting edges of the plan-
er blade
present an injury hazard! Never
20
touch the cutting edges of the planer blade
The planer blade
has two cutting edges and it
20
can be fitted either way around.
Replace the planer blade
edges are blunt.
Do not resharpen the planer blades
Reversing or replacing a planer blade
IMPORTANT INFORMATION:
Do not release the two Allen keys. They are used to
adjust the height of the blade shaft.
Adjustment is necessary only if you wish to use a
different planer blade type e.g. a profiled blade.
Always replace both blades at the same time to
avoid out of balance forces.
NOTE: If you only release one blade first then you
can use the factory-fitted second blade for orientation
when you fit the new blade.
1. Release the 3 bolts of the cutting element
using the supplied open spanner
Press the removable side guard
in the housing.
2. Push the cutting element
the blade shaft
.
17
3. Push the planer blade
the cutting element
4. Reassembly is carried out in the reverse order
with a reversed or new planer blade.
5. Planer blades
can be obtained from the
20
service address indicated (see section about
warranty).
Preparing for use
(see Fig. D)
20
when both cutting
20
.
20
18
.
26
into the slot
21
sideways out from
18
sideways out from
20
.
18
GB
.
20
20
11

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis