Before Use; Loading The Magazine; Setting The Impact Force; Use - Parkside PET 25 Originalbetriebsanleitung

Before use / Use / Maintenance and cleaning / Service
©

Before use

©

Loading the magazine

Squeeze the end of the magazine slider
(see Fig. A).
Pull the magazine slider
(see Fig. B).
5
Fill the magazine
(see Fig. C).
Note on filling with nails: Use the right-
hand slot for filling with nails as shown in the
detailed image in Fig. C. Ensure that the nail
heads are all at the top.
NOTE: Observe the maximum capacity of ap-
prox. 85 staples or approx. 75 nails when filling.
After filling, push the magazine slider
the magazine as far as it will go until you
5
hear and feel it engage.
NOTE: The magazine filling level indicator
allows you to see whether there are still staples
in the magazine.
©

Setting the impact force

NOTE: Select the lowest impact force necessary
for your stapling.
Take into account the length of the staples or nails
to be used and the strength of the materials to be
joined.
Turn the impact force controller
direction / anticlockwise to increase the impact
force.
Turn the impact force controller
direction / clockwise to decrease the impact
force.
©

Use

©
Switching on and off
Set the ON / OFF switch
switch on the device.
Set the ON / OFF switch
switch off the device.
10 GB/IE/CY
4
out of the magazine
4
with staples or nails
5
into
4
in the
3
in the
3
to position "I" to
2
to position "0" to
2
©

Stapling / nailing

Switch the device on by setting the ON / OFF
switch to position "I".
2
Press the device with its front plate
point on the surface of the material where you
wish to staple or nail.
Press the trigger
NOTE: The integral safety lock in the front
plate prevents unintentional firing.
©

Troubleshooting

Cause:
A staple or nail is blocking the device.
Solution:
Open the magazine slider
the pretension. Release the screws on the front
6
plate using the Allen key (Fig. D).
7
Remove the staple or nail.
©

Maintenance and cleaning

WARNING!
the mains plug out of the mains socket before you
clean or maintain the device.
The electric nailer / stapler is designed to be main-
tenance-free.
Always keep the device clean, dry and free
from oil or grease.
Clean the device immediately after you have
finished using it.
Do not allow any liquids to enter the device.
Use a cloth to clean the housing. Never use
petrol, solvents or cleaning agents that might
attack plastic.
©

Service

½
WARNING!
repaired at the service centre or by
qualified specialist personnel using
7
.
1
. This releases
4
DANGER OF INJURY! Pull
Have your device
at the