HAPRO Luxura X10 Anleitung Seite 14

Qsens settings menu
1 Qsens init No
255
2 Init time
3
3 Delay 1
10
4 Timer 1
5
6
Qsens settings menu
1 Qsens init No
2 Init time 255
3 Delay 1 3
4 Timer 1 10
5
6
Note:
A. Initialisation should be stopped once 'Init time' reaches 255. Do so by pressing 'Stop'.
B. The maximum initialisation time is 10 minutes.
Qsens settings menu
No
1 Qsens init
255
2 Init time
3
3 Delay 1
10
4 Timer 1
Qsens initialisation:
This is when the Qsens pipes are filled with water and air pressure.
Initialisation should only be stopped once the Qsens is spraying in a continuous flow, without
interruption.
Select Qsens init. ( 1 )
Scroll to change the setting.
Yes: Qsens initialisation starts equally and stops only when the setting is changed.
No: Qsens does not initialise or stop.
Press 'Start', the setting will be saved and the 'main settings' menu will appear.
Press 'Stop', the setting will not be saved and the 'main settings' menu will appear.
Initialising time:
This can be used to indicate the duration of the initialisation.
Select Init time. ( 2 )
Scroll to change the setting. ( 0 - 255 sec)
Press 'Start', the setting will be saved and the 'main settings' menu will appear.
Press 'Stop', the setting will not be saved and the 'main settings' menu will appear.
Delay time:
This is the delay time between start and spray time.
Select Delay 1. ( 3 )
- 14 -