Cleaning - CMi C-BKS-37-1 Gebrauchsanweisung

Kettensaege_Benzin_468260_468261.book Seite 103 Montag, 7. Oktober 2013 11:09 11
What?
Check the chain brake to ensure it is functioning
correctly.
Tension saw chain.
After each use
What?
Clean the device
Clean oil guide groove of the saw rail.
Every 10 hours of operation
What?
Clean the air filter.
Check the spark plug.

Cleaning

Clean the device
– Remove coarse dirt.
– Wipe down the device with a slightly damp cloth.
Cleaning the oil guide groove of the saw rail
NOTICE!
Device damage!
To clean the saw rail, use only a plastic spatula, never a steel tool.
– Removing the saw rail.
– Clean dirt from the oil guide groove of the saw rail with a suitable tool.
– Replace the saw rail (▸ Installing the saw rail and sawing chain – p. 94).
Checking the tensioning of the saw chain
DANGER!
Risk of injury!
A new saw chain must be re-tensioned after a maximum of five cuts. This is normal during
the run-in time; the intervals between subsequent re-tensionings will get larger.
The saw chain is tensioned correctly if it lies close against the underside of the saw rail and can be
moved easily by hand.
– Loosen the chain brake (snap in the hand guard towards the back).
– By turning the saw chain by hand, check to see that it is running correctly.
– Readjust tension of the saw chain when necessary (▸ Tightening the chain – p. 95).
Cleaning and maintenance
How?
▸ Checking the chain brake – p. 104.
▸ Tightening the chain – p. 95.
How?
▸ Clean the device – p. 103.
▸ Cleaning the oil guide groove of the saw rail –
p. 103.
How?
▸ Replacing the air filter – p. 104.
▸ Cleaning/replacing the spark plug – p. 105.
468 260 V 01 10/2013
GB
103