Werbung
IMPIANTO ELETTRICO
ELECTRIC SYSTEM
INSTALLATION ELECTRIQUE
ELEKTRISCHE ANLAGE
+-
INSTALACION ELECTRICA
Generator (1)
It is consisting in a 12V - 120W alternator placed into the R.H. side cover of
the engine.
Digital E.C.U. (2)
This device is set on the front of the motorcycle near the headlamp.
Voltage regulator (3)
The voltage regulator is placed on a small plate located on the lower side of
the steering sleeve.
Spark plug (4)
Use NGK C7E or CHAMPION G59C (for competitions use NGK C8E) spark
plugs; the spark plug gap is 0.023÷0.027 in.
Clean the dirt away from the base of the spark plug before removing it from
the cylinder.
It is very useful to examine the state of the spark plug just after it has been
removed from the engine since che deposits on the plug and the colour of the
insulator provide useful indications concerning the heat rating of the plug,
carburation, ignition and general engine condition.
Before refitting the plug, thoroughly clean the electrodes and the insulator using
a brass-metal brush.
Apply a little graphite grease to the plug thread; fit and screw the plug home
by hand and then tighten to the correct torque using a plug spanner.
Plugs which have cracked insulators or corroded electrodes should be
replaced.
M.10
N° 8000A2943 (09-03)
Quicklinks ausblenden:
Werbung
Kapitel
