Important Safety Instructions; Safety Notices Specific To The Device - Parkside PSZ 250 B2 Bedienungs- Und Sicherheitshinweise

Introduction / Important safety instructions / Safety notices specific to the device
During transport and storage the temperature may
be between -25 °C and 55 °C. The maximum per-
missible temperature is 70 °C.
Important safety
instructions
Please read all safety information
and instructions. Failure to observe the safety infor-
mation and instructions can result in electric shock,
fire and / or serious injury. Keep all safety instructions
and directions for future use!
Always verify the mains voltage matches the
voltage on the nameplate. If the mains voltage
is not suitable, abnormal device operation and
personal injury may result.
The power supply must have earthing and be
protected by an earth leakage circuit breaker.
Hoisting loads exceeding the rated load is pro-
hibited.
Only use the device for the intended purpose.
Never hoist persons with the cable hoist.
Do not unplug from the socket by the cable.
Keep the cable away from heat, oil, and sharp
edges.
Never attempt to hoist fixed or blocked loads.
Remove the mains plug from the socket after
every use.
Keep children and other unauthorised persons
away from the device.
Pulling loads sideways or from one side is pro-
hibited. Prevent the load from swinging.
Ensure the hook
8
on the push button
Regularly check the cable hoist for damage.
The push button
10
Always have repairs and maintenance performed
by an electrician at an authorised specialist
workshop. repairs must be performed by an
electrician to prevent operator accidents.
Avoid rapid start-up and powering off (inching
mode).
Always be attentive whilst operating the cable
hoist.
Never stand or work below the hoisted load.
100684_par_Seilhebelzug_content_IT.indd 15
moves in the direction shown
.
10
must be in good condition.
Hoisting stuck or jammed loads is prohibited.
Always pull the mains plug before executing
settings on the device.
The cable hoist is not suitable for transporting
hot and / or molten materials; the cable hoist is
further not suitable for use in low temperatures
or in environments with severe weather (see
Technical Data).
The service life of the cable hoist is approx.
8000 cycles (excl. wear parts). Once the hoist
has reached 8000 cycles all mechanical parts
must be inspected and overhauled.
Read and understand the operating instructions
before using the cable hoist.
Ensure the operator is familiar with the functiona-
lity of the device and how it should be operated.
The user must always operate the device in
accordance with the operating instructions.
The hoist is not intended for continuous operation.
The duty type is:
Intermittent duty without the effect of starting.
After opening the packaging, please inspect the
device, the steel cable, the hooks, the maximum
cable length lever and the auto-stop mechanism
lever for transport damage.
Safety notices
specific to the device
The user must hoist the load from the ground at
the slowest possible speed. The cable must be
tightened when the load is being hoisted.
The electric cable hoist is not equipped with
a rated power limit. Therefore do not continue
attempting to hoist the load if the overheat pro-
tection limits operation. In this event the load
exceeds the rated power of the cable hoist.
Do not leave suspended loads unattended wit-
hout taking the appropriate safety precautions.
Secure the device with a 10 A fuse or a 10 A
earth leakage circuit breaker to protect the
electric circuit.
Do not use the lever /
4 5
These are only intended as emergency stopping
devices.
as a routine stop.
GB/MT 15
02.07.14 12:41