Inserting Batteries Into The Remote Control - Grundig BT 1000 DAB+ Bedienungsanleitung

CONNECTION AND PREPARATION
Connecting the power cord
Notes:
Check that the mains voltage on the type
7
plate (on the bottom of the device) corre-
sponds to your local mains supply. If this is
not the case, contact your specialist dealer.
All the other devices/loudspeakers must be
7
connected before you connect the power
cord.
1 Insert the power cord into the
on the device.
2
Plug the power cord into the wall socket.
Caution:
The device is connected to the mains with
7
the power cord. Pull out the power plug if
you want to completely disconnect the de-
vice from the mains.
Make sure the power plug is easily acces-
7
sible during operation and not hindered by
other objects.
Inserting batteries into the
remote control
1
2
3
»AC ~ « socket
Open the battery compartment by pressing
down on the catch and then remove the lid.
Observe the polarity marked on the base of
the battery compartment when inserting the
batteries (2 x 1.5 V, UM 4/R03/AAA).
Close the battery compartment.
Notes:
Do not expose the batteries to extreme heat,
7
caused for example by direct sunlight, heat-
ers or fire.
Remove the batteries when they are flat or
7
when you know that the device will not be
used for a long period of time. The manufac-
turer accepts no liability for damage caused
by leaking batteries.
Environmental note:
Batteries, including those which do not con-
7
tain heavy metal, should not be disposed
of with household waste. Always dispose
of used batteries in accordance with local
environmental regulations.
---------------------------------------
ENGLISH 25