Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 72
8
www.electrolux.com
2. Remove the insulating paper that
covered battery like picture B
3. Insert the battery bracket into remote
control like picture C
Note: Please use this remote control
within 6 mters distance, please make
sure the control angle within 30 dgrees.
4.3 Normal Mode Operation
Under normal mode, user can adjust the
temperature according to their own
desire by pressing
temperature will range from 15°C to
36°C.
Timer setting:
1, Timing Shutdown: User can also book
the time to shut down the unit automati-
cally according following step:
When the unit is in working state, long
press timer button
enter into shutdown timer setting, digit 00
and
will display, user can use
and
to select the time that want to
B
C
or
button,
for 3 seconds to
shut down the unit, time will range from
00, 01, 02 to 23 (ie. 02 stand for the unit
will shut down automatically after 2
hours). User can comfirm the setting by
pressing timer button
waiting for 3 seconds.
2. Timing Start: User can also book the
time to start the unit automatically
according following step:
When the unit is in standby state, user
can set the timer to start the unit
according to same step with timing
shutdown.
Note: If you switch to other modes
(HOME/OFFICE/CABIN), the timer
setting will be cleared automatically.

4.4 Mode Setting:

This heater also equipped with 3
intelligent modes HOME/OFFICE/CABIN.
User can select different mode according
to their needs by pressing button
Note: Current date and time need to be
set before using Mode. Please set the
time according above Date/Hour/Minute
setting steps.
4.4.1 Home Mode Setting:
Defaulted value of high temperature is
23°C, low temperature is 18°C as below:
Note:There are 4 peroids(P1,P2,P3,P4)
in program, the period time is fixed.
P1: 08:00-16:00 18°C
P2: 16:00-23:00 23°C
P3: 23:00-06:00 18°C
P4: 06:00-08:00 23°C
The defaulted temperature will cycle
every day. User can also change current
default tepetature of current period, but it
will come back to default value in next
cycle.(Example: Current time is 9:00,
user can set teperature to 20°C, then
temperature will stay in 20°C from 9:00
to 16:00, next day it will back to 18°C).
again or
.
P

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis