Cleaning And Maintenance; Storage; Electrical Connection; Disposal And Recycling - Parkside PBS 350 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

When producing angled cuts, only use the parallel stop to
the right of the saw band.
12.3 Freehand cuts (Fig. 19)
One of the most important features of a band saw is the ease
with which it can cut curves and radii.
• Lower the saw band guide (5) onto the workpiece (see
9.5).
• Switch on the saw.
• Press the workpiece firmly onto the saw bench (7) and
slowly slide into the Bandsaw blade (21).
• In many cases it is helpful to roughly saw curves and cor-
ners approximately 6 mm from the line.
• If it is necessary to saw curves that are too tight for the saw
band used, auxiliary cuts must be sawn up to the front face
of the curve, so that these fall off as wood waste when the
final radius is sawn.

13. Cleaning and maintenance

Warning! Prior to any adjustment, maintenance or service
work disconnect the mains power plug!
Cleaning
Keep all safety devices, air vents and the motor housing free
of dirt and dust as far as possible. Wipe the equipment with
a clean cloth or blow it with compressed air at low pressure.
We recommend that you clean the device immediately each
time you have finished using it.
Maintenance
There are no parts inside the equipment which require ad-
ditional maintenance.

14. Storage

Store the device and its accessories in a dark, dry and frost-
proof place that is inaccessible to children. The optimum stor-
age temperature is between 5 and 30˚C.
Store the power tool in original packaging.
Cover the electrical tool in order to protect it from dust and
moisture.
Store the operating manual with the electrical tool.

15. Electrical Connection

The installed electric motor is connected and is ready to work.
The connection complies with the relevant VDE and DIN regu-
lations. The customer-side mains supply and the used exten-
sion line must meet these regulations.
Important information
In the event of an overloading the motor will switch itself
off. After a cool-down period (time varies) the motor can be
switched back on again.
Defective Electric Connection Lines
Often, insulation damages occur on electrical connection
lines.
Causes are:
• Drag marks if connection lines are led through window or
door clearances.
• Kinks due to improper attachment or routing of the con-
nection line.
• Cuts caused by running over the connection line.
• Insulation damages caused by pulling the connection line
out of the wall socket.
• Fissures caused by the ageing of the insulation.
Such defective electric connection lines must not be used and
are hazardous due to the insulation damages.
Regularly check the electrical connection lines for damages.
Please make sure that the connection lines are disconnected
from the mains supply during the check.
Electrical connection lines must comply with the relevant VDE
and DIN regulations. Only use connection lines labelled with
H05VV-F.
The labelling of the connection cable with the type specifi-
cation is required.
AC motor
• The mains voltage must be 230 - 240 V~
• Extension cables up to 25 m long must have a cross-section
of 1.5 mm .
2
Connections and repairs of electrical equipment may only be
carried out by an electrician.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate

16. Disposal and recycling

The equipment is supplied in packaging to preven it from be-
ing damaged in transit. The raw materials in this packaging
can be reused or recycled.
The equipment and its accessories are made of various types
of material, such as metal and plastic. Defective components
must be disposed of as special waste. Ask your dealer or
your local council.
GB/IE 21