Inserting/Removing The Battery; Checking The Battery Charge Level; Recharging The Battery; Used Batteries - Parkside PHA 12 A1 Originalbetriebsanleitung

and information relating to environ-
mental protection.
• Defects resulting from improper han-
dling are not covered by the guarantee.
Inserting/removing the
battery
1. To remove the battery (1) from the de-
vice, press both release buttons (2) on
the battery and pull the battery out.
2. To insert the battery (1), push the bat-
tery along the guide rail into the de-
vice. You will hear it click into place.
Checking the battery charge
level
The battery's (1) charge level is indicated
by the charge state indicator.
• The charge level of the battery is
indicated by illumination of the corre-
sponding LED lights while the device is
in operation. Press and hold the power
button to view.
red-yellow-green => Battery fully charged
red and yellow
=> Battery half charged
red => Battery needs

Recharging the battery

Allow a hot battery to cool before
charging.
Charge the battery (1) when only
the red LED on the level indicator is
illuminated.
The charging time for the PAPK 12
A1 (2.0 Ah) totals around 1 hour.
to be charged
1. Remove the battery (1) from the appli-
ance if necessary.
2. Plug the battery charger (3) into a
mains outlet.
3. Insert the battery (1) in the charging
compartment of the battery charger (3).
4. Unplug the battery charger (3) from the
mains.
5. Pull the battery (1) out of the battery
charger (3).
Overview of the LED indicators on
the charger (3):
Green LED (5) lights up with-
out battery inserted:
Charger ready.
Green LED (5) lights up:
Battery such alleged charged.
Red LED (4) lights up:
Battery charging.

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable safe-
ty instructions as well as the environmen-
tal protection regulations and information
(see "Cleaning and Maintenance").

Storage

• Store the equipment between 10 ° C
and 40 °C. During storage, avoid ex-
treme cold or heat so the battery does
not lose power.
GB IE NI
9