Canon EOS C300 Mark II Bedienungsanleitung Seite 4

Using an EOS C300 Mark II Camera with Cinema Lock
Attaching an EF Lens
1 Set the Q switch to OFF.
2 Turn the mount handle clockwise until it stops.
3 Remove the body cap from the camera and any dust caps from the lens.
4 Align the lens and mount making sure that the index marks are aligned.
• EF lenses: Align the red mark on the lens with the red EF Lens mount index
mark on the camera.
• EF-S lenses: Align the white mark on the lens with the white EF-S Lens
mount index mark on the camera.
5 After the lens is attached to the camera, without turning the lens, turn the
mount handle counter-clockwise until it is tightened firmly.
Removing an EF Lens
1 Set the Q switch to OFF.
2 While holding the bottom of the lens, turn the mount handle clockwise until it
stops.
• Make sure not to drop the lens when removing it.
3 Remove the lens and replace the body cap on the camera and the dust cap on
the lens.
Additional Specifications
The following specifications only add information relevant to a camera with an EF lens mount with Cinema Lock. For the full list of
Specifications
specifications, refer to
• Dimensions (W x H x D)*
Minimal configuration with thumb rest: 149 x 183 x 183 mm (5.9 x 7.2 x 7.2 in.)
Configuration with grip unit and grip belt: 190 x 183 x 187 mm (7.5 x 7.2 x 7.4 in.)
• Weight *
Camera unit only: 1,850 g (4.1 lb.)
Camera with grip unit and monitor unit**: 3,165 g (7.0 lb.)
Camera with grip unit, bracket, handle unit and monitor unit**: 3,515 g (7.7 lb.)
* All measurements and weights are approximate.
** Working configuration includes also battery pack (BP-A30 x1), recording media (CFast card x2), and unit cables (x2).
in the Instruction Manual (A 210).
2
Index mark