HANSGROHE 10700 Serie Montageanleitung Seite 15

XXX = Colors
000 chrome plated
090 chrome plated/gold plated
120 chrome plated/porcelain colour
420 platin
800 steel
810 satinox
820 brushed nickel
830 polished nickel
Fault
Insufficient water
Crossflow, hot water being forced
into cold water pipe, or vice versa,
when mixer is closed
Spout temperature does not
correspond with temperature set
Temperature regulation not possible - Temperature regulator dirty or
Safety stop button not operating
Valve stiff
Shower / spout dripping
English
Cause
- Supply pressure inadequate
- Regulator filter dirty
- Shower filter seal dirty
- Backflow preventers dirty or
leaking
- Thermostat has not been adjusted
- Hot water temperature too low
calcified
- For new installations: basic body
incorrectly connected (should be:
cold right, hot left) or installed with
180° rotation
- Spring defective
- Button calcified
- Shut/off unit damaged
- Dirt or sedimentation on valve seat,
shut-off unit damaged
Remedy
- Check mains pressure
- Clean filters
- Clean filter seal between shower
and hose
- Clean backflow preventers,
exchange if necessary
- Adjust thermostat
- Increase hot water temperature to
42 °C to 65 °C
- Clean temperature regulator,
exchange if necessary
- Install function block turned through
180°
- Clean spring and/or button,
exchange if necessary
- Exchange shut-off unit
- Clean or exchange shut-off unit
15