Electrical Safety - Parkside PUB 500 A1 Originalbetriebsanleitung

GB MT
ment for purposes for which it is
not intended.
• Always inspect the equipment
before it is to be used. Do not
operate the equipment if safety
devices, parts of the cutting de-
vice or bolts are missing, worn
out or damaged.

Electrical safety:

CAUTION! The following
states how to avoid accidents
and injuries due to electric
shock:
• Never cross the extension cable
while the device is operating.
Always keep the extension ca-
ble behind the device operator.
Should the power cable be-
come damaged during work,
then instantly disconnect the
power cable from the mains.
DO NOT TOUCH THE POWER
CABLE BEFORE IT HAS BEEN
DISCONNECTED FROM THE
MAINS! Risk of electric shock.
• Before each usage, check the
mains power cable and the
extension cable for damage
and signs of aging. Do not use
the device if the cable is dam-
aged or worn. Damaged mains
power cables increase the risk
of electric shock.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
ied person in order to prevent
hazards.
22
• Check that the mains voltage
is the same as indicated on the
rating plate.
• Connect the equipment to a
power socked with a residual-
current circuit breaker that has
a rated current of not more than
30 mA.
• Protect the equipment from
moisture. The equipment must
not be moist nor operated in a
moist environment. Water entry
into the equipment increases the
risk of electric shock.
• Avoid body contact with
earthed parts (e.g. metal
fences, metal posts). There is an
increased risk of electric shock
if your body is earthed.
• Only use extension cables with
a maximum length of 75 m
that have been approved for
open-air use. The stranded cord
diameter of the extension cable
must be at least 2.5 mm
ways unreel a cable drum to its
full length so that the entire ca-
ble can be inspected for dam-
age.
• Use the envisaged cable sus-
pensions when attaching an
extension cable.
• Never carry the equipment by
its power cable. Never pull the
cable to disconnect the plug
from the mains socket. Protect
the cable from heat, oil and
sharp edges. The mains power
cable could be damaged.
. Al-
2