Grinding With The Grinding Disc; Change Grinding Disc - Parkside PDOS 200 B2 Originalbetriebsanleitung

G B I E N I
Test run:
Before starting work and after each
change of grinding disc, carry out a test
run of at least 60 seconds with no load.
Switch off the equipment immediately if the
disc runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.
Grinding with the grinding
disc
Fold down the spark protector (1)
when grinding in order to avoid
injury from sparks.
( 5) shows the direction of rota-
tion of the grinding disc.
• Place the workpiece on the workpiece
support ( 11) and slowly bring it to
its desired angle on the grinding disc
( 10).
to side in order to achieve an optimal
disc is worn uniformly. Occasionally,
allow the workpiece to cool down.

Change grinding disc

Information on replace-
ment:
• Never operate the device without
protective equipment.
• Ensure that the rotation speed
stated on the grinding disc (
10) is the same or higher than
the nominal rotation speed of the
device.
• Ensure that the grinding disc
dimensions match those of the
device.
1 2
CY
(sound test: an undamaged grind-
ing disc hanging freely on a string
will result in a clear sound if it is
tapped with a plastic hammer).
• Never re-drill a locating hole which
is too small to make it larger.
• Never use separate bushings or
adapters in order to make grind-
ing discs whose hole is too large
• Do not use any saw blades.
be made of elastic materials e.g.,
rubber, soft cardboard etc.
• Always reassemble the device
completely after replacing the
grinding disc.
Switch the device off and remove
the mains plug.
Allow the device to cool down.
Wear protective gloves when chang-
ing the grinding discs in order to
avoid cutting damages.
have different threads (left-hand
damaging the grinding disc spindle
thread ( 15), never mix up the
two grinding disc nuts (
1
remove the left-hand and right-
hand grinding disc cover (
2. Unscrew the grinding disc nuts
(10a) by counter-holding the nut
on the opposite grinding disc with
a spanner (size 19 mm).
10a)
10a).
7) and
8).