Pioneer DDJ-SB Kurzanleitung Seite 9

Playing tracks and outputting the sound
The following describes the procedure for outputting the channel 1
sound as an example.
! Set the volume of the device connected to the [MASTER OUT] ter-
minals (power amplifier, powered speakers, etc.) to an appropriate
level. Note that the output sound may be loud if the volume is set too
high.
Mixer section
HI
MIN
MID
4
MIN
LOW
MIN
FILTER
5
LPF
CUE
6
1
7
CH FADER START
8
9
4 EQ (HI, MID, LOW) controls
5 FILTER control
6 Headphones CUE button
7 Channel fader
8 FILTER FADE button
9 Crossfader
a MASTER LEVEL control
b HEADPHONES MIX control
c HEADPHONES LEVEL control
1 Set the positions of the controls, etc., as shown
below.
Names of controls, etc.
EQ (HI, MID, LOW) controls
FILTER control
Channel fader
MASTER LEVEL control
MAX MIN
BACK
PANEL
MAX MIN
MASTER LEVEL L
a
MAX 0 MIN
HEADPHONES MIX FI
b
HPF CUE MASTER LPF
HEADPHONES LEVEL
C
c
MIN MAX
FILTER FADE
ON
CH FAD
Position
Center
Center
Moved forward
Turned fully counterclockwise
2 Press the [f] button to play the track.
CUE
3 Move the channel fader away from you.
4 Turn the [MASTER LEVEL] control to adjust the audio
level of the speakers.
Adjust the audio level output from the [MASTER OUT] terminals to an
appropriate level.
Monitoring sound with headphones
Set the positions of the controls, etc., as shown below.
Names of controls, etc.
HEADPHONES MIX control
HEADPHONES LEVEL control
1 Press the headphones [CUE] button for the channel 1.
2 Turn the [HEADPHONES LEVEL] control.
Adjust the sound level output from the headphones to an appropriate
level.
Note
This unit and the Serato DJ Intro software include a variety of functions
enabling individualistic DJ performances. For details on the respective
functions, see the operating instructions and the Serato DJ Intro soft-
ware manual.
! This unit's operating instructions can be downloaded from the
Pioneer DJ support site. For details, see Downloading the latest ver-
sion of these operating instructions (p. 12).
! The Serato DJ Intro software manual can be downloaded from
Serato.com. For details, see Downloading the Serato DJ Intro software
manual (p. 12).
Quitting the system
1 Quit Serato DJ Intro.
When the software is closed, a message for confirming that you want to
close it appears on the computer's screen. Click [Yes] to close.
2 Disconnect the USB cable from your computer.
0
Position
Center
Turned fully counterclockwise
En
9