Charging The Battery Pack (See Fig . A); Dust/Chip Extraction; Connecting A Dust Extraction Unit - Parkside 315570 Originalbetriebsanleitung

Charging the battery pack (see fig . A)

CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger .
■ Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket .
The control LED
♦ The green LED indicates that the charging
process is complete and the battery pack
ready .
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged .
♦ If the red and green control LEDs
flash, this means that the battery pack
defective .
WARNING! RISK OF INJURY!
■ Always remove the battery before working on
the power tool .
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes
between successive charging sessions . Also
disconnect the power plug from the mains
power socket .
PAMFW 20-Li A1
to the high­speed
(see Fig . A) .
lights up red .
flashes, this means
has overheated and
both
into the appliance .

Dust/chip extraction

Materials containing asbestos must not be
processed . Asbestos is a known carcinogen .
WARNING! RISK OF FIRE!
■ When working with electrical appliances
which can be connected to a vacuum cleaner
via a vacuum cleaner adapter, there is a risk
of fire! In unfavourable conditions, e .g . when
sparks are flying while sanding metal or
metal residues in wood, wood dust in the bag
of the vacuum cleaner can spontaneously ig­
nite . This is a particular risk if the wood dust is
mixed with paint residues or other chemicals
and the workpiece has become hot after be­
is
ing worked for a long time . Therefore, avoid
overheating of the material being sanded
as well as the appliance . Always empty the
vacuum cleaner's dust bag before taking
work breaks .
■ Always use dust extraction .
■ Ensure that your workplace is adequately
ventilated .
is
■ Observe the regulations applicable in your
country regarding the materials to be worked .

Connecting a dust extraction unit

♦ Place the dust extraction unit
ance and fix it into place on the appliance with
the screw .
♦ Fit the angle adapter
unit .
The angle adapter
180° .
under the appli­
onto the dust extraction
can be turned by up to
GB │ MT │ 35 ■