Maintenance Intervals; Maintenance Interval Table; Sharpening The Saw Chain - Parkside PKS 2200 A1 Originalbetriebsanleitung

IE NI CY

Maintenance intervals

Regularly carry out the maintenance oper-
ations listed in the following table. The life
of the saw is extended by regular main-
tenance of your chainsaw. Furthermore,
you get optimum cutting performance and
avoid accidents.

Maintenance Interval Table

Machine part
Components of the chain brake Check, replace if required
Sprocket chain wheel (
Saw chain ( 5)
A
Saw chain ( 5)
A
Guide bar ( 4)
A
Guide bar ( 4)
A
Oil automatic system

Sharpening the saw chain

An incorrectly sharpened
saw chain increases the dan-
ger of spring-back!
Use cut-protection gloves
when you are handling the
chain or the chain bar.
A sharp chain guarantees an op-
timal cutting performance. It eats
effortlessly through the wood and
leaves large, long wooden chips.
A saw chain is blunt if you have to
press the cutting equipment through
22
Action
24) Check, replace if required
Check oil, regrind or re-
place if required
Clean and oil
Check, clean and oil
turn around
check and, where appropriate,
clean oil outflow duct
Before
every
the wood and the wooden chips
are very small. In the case of a very
blunt saw chain, no chip cuttings
result at all, only sawdust.
• The sawing parts of the chain are the
cutting elements, which consist of a cut-
ting tooth and a depth limiting projec-
tion. The vertical separation distance
between these two determines the
sharpness depth.
• The following values must be noted in
sharpening the cutting teeth:
After 10 After
hours of
every
use use
operation







