Operating The Chainsaw; Switching On; Checking The Chain Brake - Parkside PKS 2200 A1 Originalbetriebsanleitung

Operating the chainsaw

Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled. Ensure the voltage of the
mains connection agrees with the
label on the device. Make sure you
have a secure stance. Make sure be-
fore you start that the electric chain
saw is not touching anything.
Caution! Saw can oil up, see notes
on "Assembly - Mounting the saw
chain and blade"
D

Switching on

1. Check before the start, whether sufficient
chain oil is in the tank and, if neces-
sary, refill with chain oil (see Chapter
Operation Startup).
2. Connect the device to the mains volt-
age.
3. Release the chain brake, where you
shift the brake arm (3) back against the
front grip (16).
4. Hold the electric chainsaw firmly with
both hands, with the right hand on the
rear grip (1) and the left hand on the
front handle (16). Thumb and finger
must close securely over the handles.
5. For switching on, activate the switch-on
block (14) with the right thumb and then
press the On/Off switch (13), the electric
power saw runs with highest speed.
Release the switch-on block (14) again.
6. The power saw switches off when you
release the On/Off switch (13) again.
Switching for continuous running is not
possible.
Checking the chain
E
brake
The motor cannot be turned on if the
chain brake has engaged. Do not
employ the chain brake in order to
start the chainsaw or to switch it off.
1. Place the electric chainsaw onto a
solid, flat surface. It must not contact
any objects.
2. Connect the device to the mains volt-
age.
3. Release the chain brake by shifting the
brake arm (3) over against the front
grip (16).
4. Hold the electric chainsaw firmly with
both hands, with the right hand on the
rear handle (1) and the left hand on
the front handle (16). Thumb and finger
must close securely over the handles.
5. Turn on the electric chainsaw.
6. Activate the chain braking lever (3),
with running motor, with the left hand.
To do so, push the chain braking lever/
front hand protection (3) away from the
front handle (16). Chain should stop
abruptly.
7. Once the chain brake is working prop-
erly, release the on/off switch and the
chain brake.
If the chain brake does not
function correctly, you must
not use the electric chainsaw.
A slack saw chain leads to
danger of injury.
Return the electric chainsaw to
our Service-Center for repair.
IE NI CY
17