Operation - Canon RE-455X Bedienungsanleitung

3

OPERATION

Turn the power ON.
1
When the power of the RE-455X is turned ON, the POWER
indicator on the operation panel lights up.
• When the power is turned on, it takes about 20 seconds to
show an image.
• When the power is turned on, white balance and focus are
automatically adjusted.
Turn ON the power source of the other equipment to be used.
2
Either the power of the RE-455X or other equipment may be turned on first.
Put the document at the center of the document
3
table.
If no image is displayed, check to see that the lens cap has been
removed.
Focusing.
4
Auto focus will activate when the power is turned ON.
If auto focus does not bring the subject into focus, switch to manual focus.
When operation is completed, turn the power
5
OFF.
The POWER indicator goes off. The illumination lamps will go off
(if they are on). Also turn OFF the power of other equipment.
After turning the power OFF, wait at least 5 seconds before
NOTICE
turning the power ON again. Turning the power ON too soon
may cause a malfunction.
11
Power switch
The power of the RE-455X should be turned OFF when the unit is not used.
Disconnect the power cord if the unit will not be used for extended periods.
P O W E R
Operation Panel
Document table
P O W E R