Temperature Regulation; Maintenance; Cleaning And Maintenance - Igloo IBIZA Bedienungsanleitung

Remarks and indications
• It is essential to properly level the display cabinet, which prevents the loud operation of the device and
shall ensure proper water (condensate) outlet during defrosting.
• After transporting the device, wait about 2 hours before its actuation.
• The fi rst fi lling of the freezing space should be performed after its previous cooling to working temperature.
This principle should also be observed after longer pause in exploitation.
• Do not place hot products in cooling devices.
• Do not block any ventilation holes, which would hamper the cooled air circulation. It is necessary to ensure
proper airfl ow around the device (never cover the aggregate ventilation holes).
• Keep the condenser clean. Impurities may lead to overheating of the compressor and as a consequence
may result in damage of the device, which is not covered by warranty.
• Do not use electric devices inside grocery product storing chamber
• After closing the doors, do not try to use force to open them. Under pressure created inside the device is
equalled within 1-2 minutes, which enables free opening of the doors.
• Avoid unnecessary opening of the doors and leaving them open for a longer period of time.

4.1. Temperature regulation

"Igloo" and "Carel" thermostat (temperature regulators) service is described in chapter 7 (p.19 and 20)
The basic aim of a thermostat is to control the cooling aggregate to obtain the set temperature within the device
and maintain it within the determined temperature ranges. The producer enters all settings of temperature regu-
lators required for normal functioning of the device. Before primary actuation the user should control and possibly
set the required temperature inside the device on the control panel.
Digital display – displays the current temperature inside the device.
It is forbidden to interfere with systemic parameters of the thermostat, as this can lead to serious
consequences, including the damage of the cooling device!

5. MAINTENANCE

5.1. Cleaning and maintenance

All maintenance services need to be performed after disconnecting the device from power supply!
Protect electric installation against any damage or water spillage
Do not use water stream to clean the device, only a wet cloth
Do not use any sharp objects to remove dirt!
Devices with wheels cannot be used on uneven surfaces!
It is recommended to make a break in the exploitation of the device once a month in order to clean its
interior and naturally defrost the evaporator and clean the condenser.
www.igloo.pl
en
15
User manual Ibiza