Installation Procedure; Install The Wall Plate To The Wall - Canon LV-WL01 Montage- Und Installationshandbuch

■ Installation Procedure

q
Determine the position of the wall plate using the template sheet supplied with the wall attachment.
¡ From the projection distance table (page 10) and dimensions (page 11), confirm the screen size and the distance
between the projection surface and wall plate.
¡ The wall plate and the projection surface have different vertical center lines.
Align the CTR line (printed on the template sheet) with the center line of the projection surface as shown in the
illustration.
¡ Confirm where the projection surface is on the wall, and shift the position vertically or left and right as necessary.
w
Attach the template sheet to the wall.
e
Make mounting holes in the wall in the required locations.
r
Remove the template sheet.
t Mount the wall plate on the wall.
Caution

Install the wall plate to the wall

D
H
Commercially-available
M4 screws
(4 or more places)
Take note of the following points during installation. If they are not observed,
the projector may fall down and injury may occur.
● When using the wall attachment to install the projector to a wall, make sure that the wall is strong
enough to support the combined weight of the projector and the wall attachment. Before carrying out
installation, check the weight of the projector and the weight of the wall attachment, and then check
the strength of the wall. If the wall is not strong enough, provide it with sufficient reinforcement.
Example: The total weight of the wall attachment is 7.6 kg. The maximum total weight for the
projector (LV-8235UST) and its attachment is approximately 14 kg.
● Use commercially-available M12 screws to install the wall attachment as required by the structure
of the wall. The M12 screws are not supplied with the wall attachment. Do not use screws which are
smaller than M12. In addition, be sure to secure the wall attachment in at least four places.
Never use wood screws to secure the wall attachment.
0.27 inch 0.65 inch
(68 mm) (164 mm)
CTR line
Template sheet for
Center line of
installing the wall plate
the wall plate
Center line of the
projection surface
Projection
surface
0.51 x 1.30
(13 × 33)
Unit: inch (mm)
1.77 x 3.15
(45 × 80)
8.82 (224)
15.99 (406)
18.23 (463)
4