Collecting Bag For Sandblasting Material; Troubleshooting - Parkside PDSP 1000 B2 Originalbetriebsanleitung

■ The nearer you are to the workpiece, the
smaller the dispersion pattern and vice versa.
■ Do a test run on an old workpiece to find out
the correct distance/working pressure and
avoid excessive reflection from your workpiece.
Switching on:
■ Set the control dial
outlet.
■ Move the compressed air sandblaster
to the area to be worked.
■ Press the trigger
pressed air sandblaster gun
Switching off:
■ Release the trigger
pressed air sandblaster gun
■ Set the control dial
outlet.
■ Disconnect the appliance from the compressed
air source after you finish work.
NOTE
► First detach the hose from the compressed air
source before disconnecting the supply hose
from the appliance.
In this way, you avoid uncontrollable thrash-
ing about of the supply hose.
Collecting bag for sandblasting
material
NOTE
► Do not re-use surplus sand-blasting material
from the collecting bag
cleaned.
■ You can remove the surplus sand-blasting mate-
rial which has collected in the collecting bag
via the zip fastener or use a screwdriver to undo
the screw clamp
bag from the appliance.
│ GB │ IE
■ 16
to "1" to open the air
close
to start operating the com-
.
to switch off of the com-
.
to "0" to close the air
until it has been
and remove the collecting

Troubleshooting

Fault/possible cause
No material flow
The air is not dry
enough.
Air pressure too low
Attachment not sitting
correctly
Blocked sand-blasting
material pipes
Sand-blasting pattern not as expected
The air is not dry
enough.
Sand-blasting material
grain size not uniform
Sand-blasting material
impure
The attachment is worn Replace the attach-
Other defects
Please contact an expert or your retailer.
Remedy
Install a water separa-
tor in your compressed
air system.
Increase the output
pressure of your com-
pressor.
Ensure that the attach-
ment is firmly on the
appliance and that
no air escapes at the
sides.
Check that no lumps of
sandblasting material
are blocking the pipes.
Preferably, use a
blow-out gun to clean
blocked pipes.
(Wear safety gog-
gles!) Also check the
tank outlet opening.
Install a water separa-
tor in your compressed
air system.
Replace sand-blasting
material.
Clean/replace sand-
blasting material
ment
PDSP 1000 B2