Operation - Husqvarna HMI:FS5000 D Bedienungsanweisung

Warning symbols on the display
1
2
3
4
5
1. Replace the diesel particulate filter (DPF). Only
applicable for FS7000 D, FS7000 DL products that
comply with the Euro V Emission standard.
2. Machine stop engaged. To reset the machine stop
function, these 3 conditions are necessary:
• The engine start switch is in the stop position.
• The engine speed is 0 rpm.
• The cutting blade speed is 0 rpm.
3. Low fuel level.
4. No water pressure to the water cooling system for
the cutting blade. The symbol shows when there is
no water pressure and the water safety system is on.
5. Engine fault or a regeneration is necessary. Different
symbols show for different faults and for
regeneration. Select to open the fault codes view or
the regeneration view.
6. Low engine oil pressure. Refer to the engine manual
for more information.
7. Preheating. Refer to the engine manual for more
information.
8. The battery does not charge.
9. Regeneration is necessary. Refer to
on page 7 and the sections about regeneration in
the operator's manual for the product. Only
To adjust the center angle for E-track
1. Adjust the rear axle with the E-track function. Refer
to the operator's manual for the product.
2. Push the menu button 2 times to open setup menu
2.
6
9 10 11 12
6 7
10. FS5000 D: Failure in the NOx Diagnostic Control
11. Moderate engine problem. Refer to the engine
12. Engine stop. Refer to the engine manual for more
13. Engine too hot. Refer to the engine manual for more
14. Engine failure. This symbol always shows together
15. There is an error that is not related to the engine. For
16. Water in fuel. Only applicable for FS7000 D,
Regeneration

Operation

8
applicable for products that comply with the Euro V
Emission standard.
System. Only applicable for products that comply
with the Euro V Emission standard.
FS7000 D: "Tampering and Hardware Failure" in the
EAT system. Refer to the engine manual for more
information.
manual for more information.
information.
information.
with the symbols for engine stop and moderate
engine problem. Refer to the engine manual for
more information.
more information, refer to
related to the engine on page 11 .
FS7000 DL and FS7000 DMT.
13
14
15
16
Fault codes that are not
1247 - 001 - 09.07.2019