Husqvarna HMI:FS5000 D Bedienungsanweisung Seite 5

Fault codes that are not related to the engine
1
Engine
Non Engine Faults
C1F0521
2
C1F0522
Non Engine
U100088
3
1. Select to open the view for fault codes that are
related to the engine.
2. Fault codes that are not related to the engine. The
different color shows that this view is selected.
3. Go back in the menu structure.
4. Move up in the list of fault codes.
5. Move down in the list of fault codes.
6. Clear all passive fault codes.
Service timer menu
1
Modify
Service
Timers
2
3
4
5
For more information about servicing procedures, refer
to the operator's manual for the product.
1. Select to go to servicing mode. A PIN code is
necessary.
2. Indication that a message for the servicing
procedure will show when the ignition is started and
the servicing procedure is not done in time.
3. Remaining time before next servicing.
4. Indication that servicing is not done in time.
5. Go back in the menu structure.
6. Move up in the list of available servicing procedures.
7. Servicing procedure and interval.
8. Move down in the list of available servicing
procedures.
1247 - 001 - 09.07.2019
E-track Motor
Output Current Overload
E-track Motor
Output Current Openload
I/0 Controller
Software Download Failed
Clear
Replace engine oil and filter every
100 hours
Time to next service: 95 hours
Inspect radiator air filter every
50 hours
Time to next service: 45 hours
Check blade drive V-belt tension
every 50 hours
Service overdue by: 2 hours
Lubricate front wheel bearings every
50 hours
Time to next service: 45 hours
Replace hydraulic system filter
every 50 hours
Time to next service: 45 hours
Show
Lubricate front axle pivot bearings PopUp at
every 100 hours
Ignition On
Time to next service: 95 hours
9. Select to show a message for the servicing
procedure when the ignition is started.
4
Servicing mode
1
5
Hold to
Reset
2
6
Adjust
3
4
For more information about servicing procedures, refer
to the operator's manual for the product.
1. Select and hold for 3 seconds to reset the remaining
time before next servicing.
2. Indication that servicing is not done in time.
3. Select to change servicinig interval.
4. Go back in the menu structure.
5. Move up in the list of available servicing procedures.
6. Move down in the list of available servicing
6
procedures.
7. Select to show a message for the servicing
7
procedure when the ignition is started.
8
Change servicing interval
9
Modify
Service
Timers
1
Adjust
5
1. Information about the selected servicing procedure.
2. Increase the servicing interval.
3. Decrease the servicing interval.
4. Hold for 2 seconds to save the adjusted servicing
interval.
5. Go back in the menu structure.
Replace engine oil and filter every
100 hours
Time to next service: 95 hours
Inspect radiator air filter every
50 hours
Time to next service: 45 hours
Check blade drive V-belt tension
every 50 hours
Service overdue by: 2 hours
Lubricate front wheel bearings every
50 hours
Time to next service: 45 hours
Replace hydraulic system filter
every 50 hours
Time to next service: 45 hours
Lubricate front axle pivot bearings
every 100 hours
Time to next service: 95 hours
Replace engine oil and filter
Service Interval: 100 hours
New Service Interval: 100 hours
Hold to
Interval
5
6
7
Show
PopUp at
Ignition On
2
3
Save 4
5