Husqvarna HMI:FS5000 D Bedienungsanweisung Seite 11

Fault codes that are not related to the engine
Message on the
Fault code
display
U100187 Engine ECU
U100087 I/O Controller
U100088 I/O Controller
P060748 IOC MPU
P060745 IOC MPU
P060742 IOC MPU
C1F0612 Crank signal
Blade depth sen-
C1E0111
sor signal
Blade depth sen-
C1E0112
sor signal
C1D0115 Starter
C1D0111 Starter
1247 - 001 - 09.07.2019
DTC description
No CAN communica-
tion
Software download
failed
Supervision Failure
Program memory fail-
ure
General memory fail-
ure
Circuit short to battery
Circuit short to ground
Circuit short to battery
Circuit short to battery
or open
Circuit short to ground
Indication on the ma-
chine
Engine can not be
started. No machine
function can be con-
trolled.
Engine can not be
started
Blade depth can not
be displayed. Blade
depth stop can not be
used.
Engine starter can not
be controlled. Cutting
can not continue.
Engine can not be
started.
Possible action
Check damage to connectors
X1, X4, X14 and chassis har-
ness. If found, repair and re-
start system, reset fault code.
If problem still exists, contact
your service agent for further
information.
Contact your service agent.
Contact your service agent for
further information.
Check damage to key switch,
key switch connectors X30,
X32 and harness. If found, re-
pair and restart system, reset
fault code.
Disconnect sensor and reset
fault code. If fault code no lon-
ger exists check sensor and
sensor harness.
Check damage to X13 and
X14 connectors and harness
to sensors. If found, repair and
restart system, reset fault co-
des.
Contact your service agent for
further information.
Check damage to X14 and X1
connector and harness. If
found, repair and restart sys-
tem, reset fault code.
It problem still exists, contact
your service agent for further
information.
11