For Your Safety; Air Supply - Bosch 0 607 453 series Bedienungsanleitung

GS180_bu_3609929780_t.fm5 Seite 14 Montag, 4. Oktober 1999 6:03 18

For Your Safety

Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained
followed.
In addition, the Section Safety
Instructions for Pneumatic Tools
must be observed.
Before using for the first time, ask
for a practical demonstration.
Dispose of the motor vanes in a
proper manner!
The motor vanes as well as the
abraded material from the motor vanes
that is produced when in operation
contain Teflon.
400 °C since
detrimental to health can be produced.
Observe instructions for replacing vanes.
s
Disconnect the air supply.
s
Disconnect the air supply when the machine is not
in use, before maintenance work and for the
changing of the insertion tools.
Check the direction of rotation setting
before operating the machine!
Keep hands away from the rotating tool holder as
s
well as the inserted tool.
inserted tool, splinters that fly off can cause injuries.
Be careful in confined working conditions.
s
As a result of the reaction torque, injuries can occur
from squeezing or pinching.
Be careful when screwing in long screws; danger
s
of sliding off.
Place the machine on the screw/nut only when
s
switched off.
Secure the workpiece.
s
Use clamping devices or a vice to hold the
workpiece in place. In this manner, it is held more
securely than with your hand and makes possible
the operation of the machine with both hands.
Be careful of torque reaction!
s
For high torque settings and reduced operating
pressure, the clutch no longer disengages.
Bosch can assure flawless functioning of the
s
machine only when original accessories are used.
14
therein are strictly
Do not heat over
vapours that are
For breakage of the
General
. .
This unit belongs to the C L E
It is characterised by ergonomic form, non-fatiguing
operation and easy maintenance.
. . . .
Furthermore, the C L E A N units are energy saving and
low noise.
An additional advantage is oil-free operation, i.e.
– Breathing air at the workplace remains oil-free,
– No oil contamination of the workpiece or the work-
ing place,
– No oiler,
– No oil refilling.
. . . .
Operation of C L E A N units with air containing oil is
also possible.
Consumption optimized
Lubrication free
Ergonomic
Air tool with
Noise reduction

Air Supply

The supplied air must be free of foreign material and
humidity to protect the
contamination and rust.
The use of a pressurised air maintenance unit is
necessary.
All fittings, connecting lines and hoses must be
dimensioned for the required air pressure and volume.
Avoid restrictions in the air supply resulting from, e.g.,
pinching, kinking or stretching!
In case of doubt, measure the pressure with a
pressure gauge at the air inlet with the unit switched
on.
Maintenance Unit
The maintenance unit ensures fault-free functioning of
pneumatic tools.
It consists of two main components:
– Filter with water separator
– Pressure reducing valve.
Observe the operating instructions of the maintenance
unit.
. .
A N product line.
unit from damage,