Monacor Measurement DMT-2050 Bedienungsanleitung Seite 20

GB
5.4 Continuity check
1) Set the orange sliding switch (5)
2) Apply the test prods to the corre-
5.5 Manual range selection
The measuring range for voltage and
resistance measurements is always
automatically selected in an opti-
mum way unless the symbol
shown on the top right of the display.
1) To hold a measuring range se-
20
"OL" (overload) displayed, the
diode has a forward voltage
higher than 2 V (e. g. in case of
LEDs), or it is interrupted, con-
nected
(reverse the polarity of the diode),
or not connected.
However, never perform a conti-
nuity check when voltage is ap-
plied, otherwise the measurement
will be inaccurate.
to the upper position
Press the button
many times until the buzzer sym-
bol is displayed.
sponding measuring points. The
internal buzzer will sound if the
forward resistance is less than
35 Ω. In addition, the resistance
will be displayed. With "OL" (over-
load) displayed, the value is
higher than 339.9 Ω.
lected automatically, press the
in reverse direction
Ω /
(4) so
Ω / /
.
/
is